Rug Underlay Anti Slip

A good underlay does two jobs at once: it stops a rug from slipping or creeping underfoot, and it significantly extends the rug's lifespan by cushioning it against everyday wear.

Suitable for a range of surfaces including carpet, ceramic tile, concrete, wood, laminate and vinyl floors, this anti-slip underlay comes pre-cut to size, so there's no trimming or guesswork involved in getting the fit right.

Available in four sizes: 160 x 230cm, 200 x 300cm, 250 x 350cm, and 290 x 390cm.

Features:

• Prevents rugs from slipping or creeping
• Extends rug lifespan through added cushioning
• Suitable for carpet, tile, concrete, wood, laminate and vinyl
• Available in four pre-cut sizes: 160 x 230cm, 200 x 300cm, 250 x 350cm, 290 x 390cm

How to lay your underlay:

1. Re-roll the rug and set it aside.
2. Lift the underlay and thoroughly vacuum or clean the floor beneath it.
3. Turn the underlay over (face up) and rotate it 180 degrees (end for end).
4. Ensure the underlay is completely unfolded and lying perfectly flat, with no creases or folded sections.
5. Smooth out any trapped air pockets and position the underlay exactly where you would like the rug to sit. Using a tape measure and a small amount of masking tape to mark the correct position can help achieve an accurate placement.
6. Carefully position the rug so it is square on the underlay, leaving approximately 3–5cm of underlay inset from each edge of the rug. You may need to lift and reposition the rug a couple of times to achieve the correct alignment.
7. We recommend that two people carry out this step to make positioning easier and to avoid wrinkling or moving the underlay underneath the rug.

Taking the time to follow these steps carefully will help ensure the rug sits flat, remains stable, and looks its best.

A properly laid underlay is the difference between a rug that stays put, and one that doesn't.